Henning 10.75# Recoil Spring - this is the spring specifically designed and tuned for use with IPSC/USPSA major loads.

Henning TiteFit Slide Stop Pin - this pin replaces the factory slide stop pin.  Henning's TiteFit Slide Pin is made out of shock-resisting S7 tool steel and hardened to Rockwell 45. The OD is 0.198" (factory 0.195") which ensure a tighter lockup of the barrel. It is made to only sit 0.020" proud on each side of the frame so it will look good and make the gun slick and not snag on anything.

Henning XL Firing Pin - extra long firing pin for all large frame Tanfoglio / EAA guns. This performance firing pin designed for competition and reliability is the lightest, fastest firing pin available for the Tanfoglio pistols and weighs 33% less than the factory pin.  It is made out of 420 Stainless steel and has a Rockwell hardening of 50!  It eliminates light strikes and allows for use of light hammer springs. Combine with a Wolff 13lb, 14lb or 15lb hammer spring for a lighter trigger pull, yet 100% ignition.  If you like to use rifle primers, you have to use this long firing pin to set them off.

EAA Henning Contour Grips - These grips are ergonomically shaped to fit your hands and thoughtfully machined to fit tight in your frame. They are all made out of 6061 aluminum and have been hard anodized and checkered. Standard color finish is a hard gray finish priced at $155.  A custom black grip is also available and priced at $170.  These grips are made to fit a Large Frame gun with a factory magwell. The factory models include "Elite Gold Team" and "Elite Limited". Will also fit the "Standard" frame Steel, Match & Stock models when retro-fitted with a magwell.

Wolff Reduced Power Hammer Spring - use this spring to lighten your trigger pull. 

Henning Prepped EGW Hammer/Sear Combo - this combo has been hardened for long life and has modifications made for great improvement in the EAA single action model guns action break, including polished sear face and modified trigger reset leg.  This hammer and sear combo must be used together so are offered as a package.  If you try to do a trigger job on the factory hammer and sear, it won't last.  Once you cut thru the shallow initial hardening on the factory parts, the metal is so soft underneath your action job won't last unless you use these parts.  These parts need to be installed and fitted by a qualified gunsmith.