Spring Kits, Springs, and Stainless 9mm Mag Spacers

This is the best spring/follower combination available in my opinion.  Completely and totally reliable.  Many shooters report getting one additional round in their mags, as I did in my 140mm and 170mm 9mm open tubes.  Newly redesigned follower attaches to the spring in a manner that provides better bullet nose attitude, and prevents the annoying habit some followers have of coming off the spring when the mag is disassembled for cleaning.  This new follower design allows for more consistent lockback of the slide, or if the slide lockback is disabled there is extra clearance to prevent binding as the slide comes forward.  The kits work in both STI and SV tubes. 

FKS-13 features a 13 coil spring designed for use in 38 Super and 40 S&W magazines longer than 140mm, or in 140mm mags if/when maximum spring tension is desired.  This kit can also be used for 9mm Major if you're using magazines without spacers.  If you use basepads that extend the tube length beyond 140mm, or have 170mm tubes then you definitely need to run the FKS-13. 

FKS9-13 is for 9mm Major when using magazines with spacers.  Features a shorter follower than the FKS-11 or 13 to allow for the magazine spacer.  This kit has a 13 coil spring, so again you have the option to run 11 or 13 coil springs depending on your tube length.  Simply cut two coils off the bottom of the spring if a 11 coil spring is desired. 

FKS-11 is for 140mm or shorter magazines in 9/38/40, when spacers aren't being used, and maximum capacity is desired.  While you will give up a bit of spring tension over the FKS-13, you will get the maximum number of rounds in your mags while still having enough spring tension to reliably feed the gun.

Spare magazine springs and stainless steel spacers are available below.