|
|
|
|
EGW EAA Firing Pin - this oversize pin fits the slide within .001 to eliminate primer shear. Prevents primer flow around the firing pin and prevents contaminates from entering the firing pin channel and preventing positive ignition. Fits P9 and EAA guns in 9mm and .40.
EGW EAA Hardened Slide Stop Pin - this pin replaces the factory slide stop pin. This pin is hardened to ensure long life. Fits 9mm and .40.
Henning-Built 40 S&W Magazine - 21 round extended capacity magazine created for USPSA and IPSC competition, as well as anyone who wants higher capacity in their pistols. These mags will allow the OAL to be reloaded out to max length. Features a factory magbody assembled and ready to go with the Grams follower & spring kit cut to correct length with a HENNING H-140 basepad. Pad is secured to tube with a 4-40 allen screw which requires a 0.050" allen tool for disassembly. Available with either black, or the trendy new slate gray basepad. These magazine are for the large frame guns! If you are not sure what frame you have, check your mags. Large frame mags measure 1.345" x 0.850".
Henning H-140 Basepad - anodized black pad can be installed on a factory magazine with the new follower/spring kit without any modification to the magazine to be legal for USPSA Limited Division. This setup gives you a reloadable 20 rounds right off the bat, and after a while you will be able to fit 21 rounds in the magazine when the spring has taken a set. You will not be able to reload to 21 rounds, but you can start with 22 in the gun. This basepad is for a large frame gun! If you are not sure what frame you have, check your mags. Large frame mags measure: 1.345" x 0.850".
Henning XL Firing Pin - extra long firing pin for all large frame Tanfoglio / EAA guns. This performance firing pin designed for competition and reliability is the lightest, fastest firing pin available for the Tanfoglio pistols and weighs 33% less than the factory pin. It is made out of 420 Stainless steel and has a Rockwell hardening of 50! It eliminates light strikes and allows for use of light hammer springs. Combine with a Wolff 13lb, 14lb or 15lb hammer spring for a lighter trigger pull, yet 100% ignition. If you like to use rifle primers, you have to use this long firing pin to set them off. This firing pin sits just flush with the breech face of the slide which makes it virtually impossible to have any primer blowback. Should only be used with single action model guns! Overall length is 2.640".
Grams Mag Kit - the ticket to increased magazine capacity in your 140mm .40 S&W, 10 mm or 38 super magazines. Switch out the factory follower and spring with this 11 coil Grams spring & follower kit. This is for large frame magazines! If you are not sure what frame you have, check your mags. Large frame mags measure: 1.345" x 0.850". |
|
|
